I. Seal: in the course of use, must be required to access, such as the addition of other ingredients in the wax emulsion, must be used once; the original liquid wax solution is not used in particular need to pay attention to its bag must be tight again, the container Must be tightly sealed tightly. Otherwise, its surface is very easy because of the evaporation of water caused by the formation of a layer of film, thus affecting the further use. In addition, the lid is not tight, but also easy to enter the dust and other foreign body, and even into the bacteria / mold, resulting in smelly mold; II. Room temperature: 5-35 ℃. Higher than 40 ℃ easy to condense into a solid, non-volatile content of the higher the emulsion, the more easily because of high temperature deterioration. Less than 0 ℃ easy to freeze, non-volatile content of the lower emulsion, the more easily because of low temperature deterioration. For most emulsified waxes, both can cause irreversible damage; III. Indoor: Avoid direct sunlight caused by local overheating and cold air straight blows caused by local cooling and affect the stability of wax emulsion products. Emulsion wax transport Note: I. avoid high altitude instability, fall, fall, causing the barrel to break, emulsified wax spilled to cause waste; II. To avoid placing in a sharp protruding trunk or other goods, otherwise lead to barrel Destruction, emulsified wax outflow, both waste may affect other goods; III. Summer attention to high temperature, winter attention to low temperature.